Відео

How do you know what approaches are the most realistic as you displayed lots of options on both arrival and departure there? Thanks

Thank you🎉

.

not msfs btw

I flew into Juneau many times and always admired the pilots maneuvering the plane to smooth landing. AK airline pilots are the best.

How do you get these sky colours? I love the blue sunset. Please let me know.

The framerates are bordering over the 60fps mark but not sure if everything is totally maxed out. But why are you spending so much time on the tarmac and inside the cockpit. Would be interesting to see the plane in external view flying over dense areas like New York or Tokyo to see how the 4090 copes fully squeezed dry.

So, even with the A320 immersion installed some of the new effects won't show due to aircraft being encrypted?. That's a joke?

What’s your pc specs etc ?

3:42:29 Thank you very much, that feedback is always really appreciated :D Glad you enjoyed my service, even though it was incredibly busy and chaotic (in total almost 3 hours of more or less non stop talking, and no GND/DEL to help). The stand assignment wasn't intentional to troll you. I actually think these weird taxi-out-turn positions like A1 are fun, i always love them as a pilot and many manually request them too, but the assignmwent was random. Our ATC client automatically decides for stands realistically based on the airline, aircraft and departure airport. That automatic assignment likes to have planes make airport tours apparently, so that answers your question from 3:46:35. A couple of the A-stands nearby were pre-assigned for other arrivals but in the end it could have been any of them for you. You just got lucky to get to do the extra fun parking job. Looked great though, I've seen all kinds of horrendous attempts at parking there already.... Greetings from Frankfurt Tower :) hope to see you in FRA again at some point

Cool😎

Did you show the water dripping off the plane like they show in the promo video? I had to go

Which addon are you using for EGLL

Great stream mate, at EGLL how did you get the boards opposite the cockpit at the gate to show the flight information? Thanks in advance!

When i do this, once I select “fly”, my plane does not take the flight plan i customized, instead it gives me a direct flight plan. (Ive set it to low altitude airways and high altitude airways)

I was sceptical. But tried it yesterday. Colours are better, but some wicked stutters and a major 4 minute freeze. CTD is inevitable. I will try again with it disabled to compare. Doesn’t really matter to me with this silly version, as I’m in anticipation of 2024 release.

Does it load the approach in the G1000NXI or higher too?

Are the small black squares buttons ?

Tabletop mountain? 😂

I followed everything, but my max reverse keeps saying 11.57 percent...

Just found this as I am thinking of buying this system. I real life the reversers work as shown in the P3D section. Pull them up to activate reverse thrust. This will be with engines idling. Then pull them up and back to go into full reverse. If uou pushed the throttles forward after engaging idle reverse, the reverse will be cancelled. So this is actually how they work in real life. For goodness sake, you should have FSUIPC on from the beginning as it connects so many things to P3D>

GPWS caution “SINK RATE” was for the VS -1200 on short final, this would be a mandatory a go around below the landing gate as you no longer meet the stabilised criteria unless previously briefed (4 degree GS) for example. The Terrain/pull up cautions were spurious, they would be inhibited in the vicinity of the AD. Just for your information, not being an armchair pilot!

thanks, what do you bind on the second Quadrant dial

The 1st one is trash 😂 The twist axis sucks

Safe travels where are you flying from and going to

I don't want heat or noide so I cap the FPS to 31 in MSFS2020 and X-Plane 12, so a 4080 or a 7900XTX is expensive enough for me.

The t flight is absolutely terrible. Cheap plastic, clunky etc. a Logitech 3D pro blows the flight out of the water despite no separated throttle.

Do you fly the fenix?? I can’t seem to steer with this yoke, it’s the only aircraft that I can’t steer, any recommendations? Thanks

I have a thrustmaster tca Boeing edition with no pedals, I’ve tried all this and still it won’t work. Any advice please

Thank a bunch, TRs are working much better.

Matt, while I respect your right to compare or review products for MSFS, is not a little hypocritical of you to do this for a product while you are employed by Microsoft? You are somewhat of an influencer, is it your place now to make negative comments about a product that is part of flight sim history? It is part of what has made you a UA-cam presence. I am a little disappointed in your presentation of ASFS.

That was quite interesting... Thank you!

Hi

They released the scenery without the full custom interior to be the first and do a cash grab before Flightbeam releases its top notch KSFO scenery...

Is all this relevant went setting it up on Xbox too?

Condensation on takeoff on wings? SimFx?

Thanks for your video! Can we have ai traffic with proper livery in xbox?

Is the 4080 super not as comparable though msi

Why does it only work for the A320?

thks friend, just bought it ! fantastic

Please tell me the cabin will be like the fenix, mainly for use able wingviews

It’s under nose wheel steering. Not hard, if you’re going to make a video tutorial at least do your 5 minutes of research to find that out

Sad to hear about Bonza’s demise today…

💩

Dude, you are talking way too fast...

Wow thank you for this video!! My Tiller is not working i will check my settings.

Awesome mate, great help ! I had most things correctly setup, just minor adjustments. By the way, Winwing FCU1 for Fenix A320 is great ! It’s addition worth considering :)

Awesome mate ! Best tutorial in this subject I've seen :)

Which graphics addon do you use?

How do you get passengers to go the whole jetway because mine passengers just go the half of the jetway